圣霖輥道咨詢客服

工作輥道靠近工作機座，在工作機座前后將軋件喂入軋機，軋制后接住軋件，又返回送入軋機進行軋制，直到軋成成品后送到下一工序。工作輥道又分為機架輥道、主要工作輥道和輔助工作輥道。機架輥道是指裝在工作機座的機架中的少數幾個工作輥。

The work roll is close to the working stand, and the workpiece is fed into the rolling mill before and after the machine seat. After rolling, the workpiece is received and rolled back to the mill for rolling, until the finished product is sent to the next process.

The work roller table is also divided into the roller table, the main working roller and the auxiliary working roller.

The rack roller is a few work rolls in the frame of the working frame.

中間輥道位于拉矯機和切割設備之間，用于支承和輸送鑄坯和輸送引錠桿。拉坯時，中間輥道與拉速同步，送引錠桿時可以用較高的速度。切割區輥道為切割區四周的輥道，該輥道中有幾個輥子需要升降或擺動，以防止切割時切壞輥子和切割渣粘結輥面。

The middle roller is located between the pull straightening machine and the cutting equipment, which is used to support and transport billets and to transport ingot bars. The middle roller, and casting speed synchronization, you can use a higher speed to send dummy bar.

The roller section of the cutting area is the roller table around the cutting area, and there are several rollers that need to rise or swing in the roller way, so as to prevent the roller and the cutting slag from sticking to the roller surface when cutting.

支架多用型鋼制成，有焊接和螺栓連接兩種結構。為了通用和便于制造，已把上述三種常用輥子的支架作成具有標準長度的通用構件，在設計時可直接選用。

The  is made of  steel with two structures: welding and bolt connection. For the  of generaland convenient manufacturing, the above three common roller  have been used as a common component with a standard length, which can be used directly in the design.

對于大型軋機來說，尤其是熱軋機必須用動力傳動輥道。多的還是集體傳動式，特別是長度不大而軋件斷面很大時，適宜用集體傳動。單獨傳動輥道通常用于長距離的軋件的傳送。

For large rolling mills, in particular, the hot rolling mill must be powered by a power drive roller. The most important is the collective transmission type, especially when the length is small and the section of the workpiece is very large, it is suitable for the use of collective transmission. The single drive roller is usually used for the transmission of long distance parts.